Question about Zyxel XGS-PON Bridge PM7300

Not sure if I understood question correctly, but just in case - it does work with Swisscom fibre 10Gbps line. In my configuration it's set to Bridge mode (actual firewall behind XGS-PON is OPNSense).

provisioning a Mac address with Sunrise is a matter of impossibility-> change supplier

Has anyone managed with Sunrise? I think the positive reports all refer to Swisscom (as provider)?

not with me Sunrise, but with iway I got it running at the weekend with an opnsense behind it.

Hi, yes ordered and configured it last week.
I have this bridge and the ASUS GT-BE98 attached.

I had to set the Zyxel bridge to bridge mode, I deactivated the VLAN. On my Asus router I set the WAN port to VLAN10 and the Swisscom DNS. I tried to clone the MAC address of my modem, but unfortunately this did not work. I therefore decided to store the MAC address of my Asus router with Sunrise. Once this was done, I was able to enter my NSN number, OTO ID and slot at swisscom.ch/start and my router was activated. Now everything works perfectly.

Swisscom works directly. You can forget about a third-party provider like Sunrise with this device. This has to do with the firmware and NAT.

Yes, as a bridge via a Swisscom line. I use a PFsense as a firewall.