Questions about Lenco L-3808

Hello St.haeberle, No, you cannot connect passive speakers directly. The record player essentially already has an integrated preamplifier. This means that the output power of the turntable is amplified to a line level, so that you can then use the signal in a power amplifier (receiver/power amp) to drive the desired speakers. If you connect active speakers, you can also omit the power amplifier. Greetings Dave

Could you write the link, it would be easier for others to find something suitable than without a link.

You have to turn in the 2g from the suspended state, then the antiskating is always the same as the support pressure, so also 2.

Technically yes, because the Lenco has an integrated stereo preamplifier, i.e. you can use a stereo RCA cable as normal and then process the sound further. An amplifier with a phono input is not required.

Yes, but you don't need an amplifier because the turntable has one built in.

It depends on what inputs your soundbar has. The Lenco has an integrated preamp, so you can connect it to active speaker systems. Cinch is available as an output. If your soundbar has a 3.5 mm jack connection (which is unlikely), you can use a cable RCA/jack. If your soundbar has Bluetooth, you must first connect a suitable Bluetooth device, such as this one: https://www.digitec.ch/de/s1/product/sennheiser-bt-t100-bluetooth-audio-transmitter-sender-bluetooth-audio-adapter-11168818. All in all, it's a bit of a hobby. That's why I would recommend a record player with integrated Bluetooth: https://www.digitec.ch/de/s1/producttype/plattenspieler-317?pdo=1587-12774%3A197780&tagIds=591-592

I have connected the record player via an amplifier and the speakers as well.

Have you adjusted the pressure weight and anti-skating according to the instructions? The tone arm should float without sinking or rising when the weight is set correctly. Fix the weight and set the same number on the antiskating wheel. Greetings fieryjack

It is best to contact our customer service directly so that your request can be processed individually: https://helpcenter.digitec.ch/hc/de/requests/new

This will not be possible, as the USB interface is intended for data and only functions as a mass storage device with the Samsung Soundbar.

It has a "Euro plug" and not a Schuko plug. So it is a "CH plug 2-pole". Greetz

What kind of receiver do you have? I would orient the speakers to the receiver rather than the turntable.

It always depends on the tuner system. Whether it has its own earthing or not. If not, I recommend a preamplifier. There are expensive ones, but also very cheap ones. I bought one from Hama and haven't had a single problem in two years. Hama PA 506 (MM, Entry) Your record player already has an integrated stereo preamplifier. So you should be able to play the audio signal over your stereo system via an AUX input (cinch) without any problems. And record your tracks via USB on your computer. :-) And the manual says the following under point 22: 22. RCA OUTPUTS The output is a switchable PHONO/LINE output. For example: These output jacks send a low voltage "phono" output signal to the "phono" inputs of a mixer. Record players must be connected to the "phono" inputs of a mixing console. The red RCA jack points to the right input channel input channel and the white socket indicates the left input channel. So have fun with it. :-)

... have you ever compared the two ? Apparently the drive differs and with the L-3808 you can still regulate the speed into + and - (DJ).

Sie finden diverse Tonabnehmer im Link unten: https://www.digitec.ch/de/s1/producttype/tonabnehmer-309?f=&tagIds=554-591-544

Preamplifier can be added as required. Output either as line or phono.